Silvercrest SPU 900 A2 - Manual (Page 40)

- 37 -
Now switch the radio off again. The radio
function is explained on the following
pages.
When the alarm signal sounds...
• ... and the alarm function "Radio" is se-
lected, the radio switches itself on with
increasing sound volume and the last
adjusted radio station for one hour.
• ... and the selected alarm function is “sig-
nal tone”, the signal tone sounds with an
increasing volume for 10 minutes.
To close the individual alarm function press
any button except the SNOOZE/DIMMER
button y.
The Slumber function
When you press the SNOOZE/DIMMER but-
ton y, the presently active alarm is cancelled
for the time that is programmed for this func-
tion (see Section "Programme time for the
slumber function“, 1 - 59 min., standard value
= 9 min.). Meanwhile the SNZ indicator
glows in the display g. To permanently stop
an interrupted alarm, briefly press the AL.SET
button a.
The Reminder function
The appliance will remind you of the dates
that you have programmed in with the re-
minder function. In these cases and on these
days, from 08:00 - 23:00 and on every
full hour, the reminder alarm will sound for
10 minutes. Additionally, the SDA indicator
blinks in the display g. Press any button to
end the reminder alarm.
Adjusting changing display indicators
When the appliance is in Standby, press the
button DOWN i. In the display appears
" D– " (for Time and Date). Press the button
DOWN i once again, " –W " appears in the
display (for Time and World Time). Press the
button DOWN i once again, " DW " appears
in the display (for Time, Date and World
Time in rotation). Press the button DOWN
i
once again, " –– " appears in the display
(only Time).
Radio operation
The technical data of the appliance makes
possible an adjustable frequency range wider
than the permitted frequency ranges of 87,5
- 108 MHz. In some countries, different na-
tional regulations may apply to the assigned
radio frequency ranges. Please note that infor-
mation received outside of the assigned radio
frequency ranges may not be used, passed on
to third parties or otherwise misused. For VHF
radio reception, completely unwind the wire
aeriel 2) and, with the radio switched on, de-
termine the most favourable positioning for it.
Switching the radio on and off
1. Press the button l. In the display g
the current frequency and the switch-on
symbol is indicated. Next to it, the
clock symbol blinks and thus indicates
that the device is waiting for the reception
of the current time from an RDS station.
2. Press the button l once again to
switch the radio function off and return the
appliance to the standby mode.
Manual station selection
1. Press the button UP o to search for radio
stations with a frequency higher than the
one indicated in the display.
2. Press the button DOWN i to search for
radio stations with a frequency lower than
the one indicated in the display.
3. If the found radio station transmits RDS-
Data, the indicator in the dis-
play g glows. The display g indicates
the name of the radio station and the time
is updated (insofar as this adjustment is
activated, see the section "Programme the
Update function").
Automatic station search
You can also let the appliance search for
radio stations. The radio alarm then searches
the selected frequency range until it has
found a radio station.
BDA_SPU 900 A2 - IAN-90514_5_en.indd 37 22.07.2013 17:36:25