Silvercrest SBTF 10 C2 - Manual (Page 64)

61 SBTF 10 C2
GB
Rejection of a call
●
Press the multi-function button 6 for 3 seconds to
reject an incoming telephone call.
Adjusting the volume of the hands-free appliance
You can adjust the sound volume level of the hands free
device with the +/- buttons 3.
●
During a call, repeatedly press the + resp. - buttons 3
until the desired sound volume level is obtained. The
attainment of the maximum sound volume level is indi-
cated by a short signal tone.
Charging 5 V Devices
●
Check the max. input voltage (5V) and the max. power
input (1000 mA) of the device which you want to charge.
For this, consult the operating manual of the device.
●
Connect the device to be charged with the USB port 4
on the hands free device. The device now receives its
power supply from the hands free device. If the device
is equipped with a charging indicator light, this will in-
dicate that the device is being charged.
Note:
If the power supply does not activate automatically, you
should disconnect the USB cable from the USB port 4
and re-connect it.
Troubleshooting
If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:
●
Ensure that the Bluetooth
®
function in the mobile
telephone is activated.
●
Ensure that the hands-free appliance is correctly
installed, switched on and supplied with electricity.
●
If you use several Bluetooth
®
appliances, ensure that
a previously created Bluetooth
®
connection of the
mobile telephone is separated.
IB_93813_SBTF10C2_LB1.indb 61 IB_93813_SBTF10C2_LB1.indb 61 10.10.13 09:40 10.10.13 09:40