Silvercrest SHBS 5 A1 - Manual (Page 69)

66 SHBS 5 A1
GB
MT
Beard trimmer attachment
NOTE
► Comb the beard in the direction of growth to remove any knots.
► Start by setting the comb attachment 12 to a longer length and reduce this in stages while
cutting the hair.
► Please note that the corresponding cut length will only be achieved if the slide switch 2 is
set to position 3 and the appliance is being held at right angles to the skin surface.
♦ Cut the beard against the beard growth direction (upwards from chin to ear). Trim fi rst one
side and then other.
♦ Use the beard trimmer attachment 7 without the comb attachment 12 to cut the beard very
short or to add shape or trim a moustache.
♦ You can use the slide switch 2 to fi nely adjust the cut length in three steps.
Precision trimmer attachment
♦ Use the precision trimmer attachment 8 to add shape to a moustache, mutton chops, sideburns
or eyebrows.
♦ Lay the edge of the precision trimmer attachment 8 at the required level of the hair growth
and move the appliance downwards.
Ear/nose hair trimmer attachment
♦ Use the ear/nose hair trimmer 9 if you want to remove ear or nose hair.
♦ Guide the metal end of the ear/nose hair trimmer attachment 9 slowly into the nostril or ear.
♦ Move the appliance slowly in a circular motion to cut the hair.
Shaver attachment
♦ Use the shaver attachment 10 for a dry shave.
♦ Hold the appliance at right angles to the skin surface and move it gently over your face.
♦ Shave in the opposite direction to the beard growth. In complicated areas, such as the chin,
pull the skin tight to achieve a better result.
IB_96126_SHBS5A1_LB5.indb 66 IB_96126_SHBS5A1_LB5.indb 66 21.01.14 15:27 21.01.14 15:27