Setting the heating output, Selecting the temperature, Setting the timer – Silvercrest SHLF 2000 B1 User Manual
Page 16: Swivel function, Gb ie
13
SHLF 2000 B1
GB
IE
Setting the heating output
♦
Activate the appliance by selecting the heat level. To do this, press the func-
tion selector
12
or
25
until the desired heat level is shown in the display
11
:
Low heat output: appliance produces an output of 1000 watts
High heat output: appliance produces an output of 2000 watts
♦
To put the appliance into standby mode, press the function selector button
12
or
25
until the display
11
shows only the room temperature
. After a few
seconds of overrun time, the display backlight turns off .
Selecting the temperature
Using the "Increase temperature" button
13
or
21
you can set the target tempera-
ture
to a maximum 38°C. Using the "Decrease temperature" button
14
or
23
you can set the target temperature
to a minimum 6°C.
The selected target temperature
is shown on the display
11
.
The room temperature
is measured by the temperature sensor
9
.
NOTE
►
As soon as the room temperature has reached the target temperature, the
heater switches off . The ventilator continues to run. If the room temperature
falls below the target temperature, the heater is reactivated automatically.
Setting the timer
The appliance has a timer that you can use to set the desired heating duration.
Once the period is over, the appliance switches off automatically.
♦
Press the "H" button
17
or
27
to set the hours.
♦
Press the "M" button
16
or
26
to set the minutes.
NOTE
►
If you keep the buttons on the appliance pressed, the values keep increasing
until you release them. The selected time is shown on the display
11
.
Swivel function
The appliance has a swivel function. This will cause the appliance to swivel back
and forth so that the warm air is more evenly distributed throughout the room.
♦
Switch the swivel function on by pressing the button for the swivel function
18
or
22
.
♦
Switch off the swivel function by pressing the button for the swivel function
18
or
22
again.
IB_100043_SHLF2000B1_LB3.indb 13
IB_100043_SHLF2000B1_LB3.indb 13
17.06.14 15:28
17.06.14 15:28