Powerfix KH 2927-1 - Manual (Page 45)

Adding distances together
1. Measure an area as described in the chapter
"Measuring distances".
2. If necessary, press the MODE 9 button several times
until the indicator (distance measurement)
appears in the display w.
3. Press the READ q button to carry out a distance
measurement.
4. Press the RECALL 5 button. A "+" appears in the display
and the measured distance is transferred to the lower line.
5. Measure the next distance. The newly measured
distance is indicated in the upper line, the sum of the di-
stances is indicated in the lower line.
6. Repeat steps 2. to 4. to add further measurement values.
7. If you want to exit the addition mode press the
MODE 9 button. All values will be deleted.
Measuring areas
1. Switch the device on by pressing the ON/OFF 0 button.
2. If necessary, press the MODE 9 button several times
until the indicator (area measurement) appears
in the display w. The bar for the first part of the
measurement blinks.
3. Press the READ q button to measure the length.
The bar for the second part of the measurement blinks.
4. Press the READ q button to measure the width.
The width is shown in the upper line, the area in square
meters (m
2 ), as the sum of both measurements, is shown in
the lower line.
L
W
L
- 43 -