Encore electronic ENNHD-1GS - Manual (Page 54)

Type:
The file format of the connected storage device.
Size:
The size of the connected storage device.
Remove button
Click this button to safely remove the connected
device.
Format button
Click this button to format the connected device in
EXT3 file format.
Note: Always disconnect your connected USB or eSATA device by clicking the
Remove button. To remove your improperly may lead to data loss
Printer Setup
Procedures to setup the printer
Note: The device supports one connected USB printer only. Printer Connections on
both the USB ports may led the printer functioned unsuccessfully.
1. Connect the USB cable of your printer to the device. Power on your printer.
2. Open the GUI and click “Maintenance”. Install the firmware extension file to
the device..
Note: To get information for installing the printer server file, please see” Load
Firmware extensions”
3. Click USBÆ Detail, you can see the information of your printer.
53