Epson AcuLaser C9300 - Manual (Page 104)

The printer cannot clear an error message because the error status still remains. Try solving the
problem again.
Warming Up
The printer is warming up the fuser to be ready to print.
Waste Toner Box Near Full
The waste toner collector is near full of toner.
Write Error ROM A, Write Error ROM P
This message indicates an internal error in the printer. Reset the printer. If this error persists, consult
your dealer.
Writing ROM A, Writing ROM P
This message indicates that a ROM module in the slot is being written. Please wait until this message
disappears.
Wrong Password
No print jobs have been saved with the password you entered.
Wrong Photocon uuuu
An inappropriate photoconductor unit is installed. Install only the photoconductor unit listed in
“Consumable products” on page 25.
See “Replacing Consumable Products” on page 133 for instructions on replacing the photoconductor
unit. (The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow,
and Black respectively.)
Wrong Toner Cartridge uuuu
An inappropriate toner cartridge is installed. Install only the toner cartridge listed in “Consumable
products” on page 25.
See “Replacing Consumable Products” on page 133 for instructions on replacing the toner cartridge.
(The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow, and
Black respectively.)
Epson AcuLaser C9300 Series User's Guide
Using the Control Panel 104