MCZ Yari AIR - Manual (Page 30)

MENU 4
SET
RICETTA
+2
SET
RICETTA
20 : 45
OFF
28
5 - MODE AND SETTINGS
RECIPE SELECTION
If the flame is not compliant with the requirements analysed above it is necessary to set the stove in the most suitable manner based on
the type of pellets being used.
Therefore, excessive fuel consumption is avoided, the intended heating capacity is guaranteed and the product integrity is safeguarded.
Based on the aforementioned qualities (flame shape/colour/quality) and the user's experience (brazier too empty or full) it is possible to
increase or decrease pellet loading, with respect to the factory setting (0) from the menu.
THE TYPE OF LOADING CAN BE SELECTED (0 default setting +1/+2/+3/-1/-2/-3) UPON INITIAL START-UP OR EACH TIME
IT IS NECESSARY. (E.g. when the pellet supplier is changed or when a difference in colour or size is noticed).
+1 = 5% -1 = -10%
+2 = 10% -2 = -20%
+3 = 15% -3 = -30%
Memorization of recipe on stove
Press 6 MENU and use button 1 until the words “SET RICETTA” (RECIPE SET) appear on the display, then confirm with 6 MENU. At this
point the words “SCELTA RICETTA” (RECIPE SELECTION) will appear, and again using buttons 1 or 2 it is possible to choose the required
recipe number.
To confirm your choice press 6 MENU. A request for confirmation will appear on the screen, to which you will need to reply "YES" or " NO".
Select one of the two options using buttons 1 or 2 and confirm with the 6 MENU button. Confirmation of the recipe setting can be seen
on the “RICETTA CARICATA” (LOADED RECIPE) screen; the display then automatically goes back to the initial screen.
If the procedure is interrupted for more than 60 seconds, the display automatically goes back to the initial screen. It is also possible to
manually stop operation at any time, by holding key 5 down for a few seconds.
IMPORTANT NOTE: If the language setting has been changed, it will go back to the factory setting.
OPERATING MODE
Once the stove finishes its start-up phase it goes into operating mode which can be MANUAL or AUTOMATIC.
The factory settings are:
MANUAL
• Power P3
• Ventilation V1