MCZ Duo HYDRO AIR - Manual (Page 32)

1
2
30
4-INSTALLATION AND ASSEMBLY
LOADING THE PELLETS
Fuel is loaded from the upper part of the stove by lifting the door. Pour the pellets into the hopper.
This is easier if performed in two steps:
Pour half of the contents into the hopper and wait for the fuel to settle on the bottom.
Then pour in the rest.
Never remove the protection grid inside the hopper. When loading, do not let the pellet bag come into contact with
hot surfaces.
No other type of fuel other than pellets is to be inserted into the hopper, in compliance with above-mentioned
specifications.
Store the spare fuel at an adequate safe distance.
Do not pour pellets directly onto the brazier but only into the hopper.
Most of the stove surfaces are very hot (door, handle, glass, smoke outlet pipes, hopper door etc.), therefore it is
recommended to avoid coming into contact with these parts without appropriate protective clothing.
CONDUIT FOR THE AUXILIARY TANK (optional)
It is possible to purchase conduit to be fastened, using four screws, to the back of the stove, in correspondence of the knock-out panel,
first the
square and then the round piece is to be removed.
This conduit makes it possible to insert pellets into the tank through an auxiliary tank (not supplied).
LOADING THE PELLETS