Pruning shade trees and cutting saplings – Echo X52000020 User Manual

Page 26

Advertising
background image

26

PRUNING SHADE TREES AND CUTTING SAPLINGS

Whippy growth, such as saplings and tree branches, may resist being cut. Be prepared
for the saw chain to skate along the surface and the material to vibrate from side to
side. This can result in a sharp sudden pull on the saw or can cause branches to
snap back at the operator. Be ready to resist this pull and avoid snapping branches.
With the Kick Guard

®

device in place as a shield on the bar, you can flush-cut brush

and saplings close to the ground to reduce this rough cutting. The pruning of small
gauge branches may be better done with pruning saws or shears rather than chain
saws. Likewise, clearing brush or heavy weeds may be better done with a brush
cutter.

Trees have both branches and stems that look like branches, called condominant
stems. If a condominant stem must be removed, cut at an angle outside of the
bark ridge. Avoid leaving any stub.

When removing a branch, always cut outside the branch bark ridge and collar. Do
not make a flush cut when removing a main branch. You may need to undercut a
notch first to allow a hinge for the lowering process. After the branch has been cut
off, make your finished cut in the desired location.

WARNING! Do not cut while in a tree unless you are specially trained to

do so.

Branches that do not have a distinct collar should be cut at a right angle to the
branch outside of the branch bark ridge.

TRIMMING TECHNIQUE TO
AVOID BARK PEELING

Pruning Technique

DO NOT CUT UP IN TREES

When removing heavy limbs, first make an undercut several inches outside of the collar. Then remove the limb by a
second cut an inch or so outside of the first cut. Remove the stub with a third cut just outside of the collar. This process
will prevent bark peeling

WOUND DRESSINGS NOT USEFUL - Wound dressings have been shown to interfere with the natural development of
callus tissues that eventually close the pruning wound. In some cases, wound dressings can even harbor disease
organisms much like what occurs when a bandage is left on a skin cut too long. It is far more important to make a smooth
cut outside of the collar, and allow the wound area to dry.

If a wound dressing is desired for aesthetic purposes, use a very thin coat, just enough to darken the wound area. The
best are the aerosol sprays of water emulsified asphalt sold in garden centers. Do not use oil-based paints, thick tars or
other materials containing petroleum solvents.

MAINTAIN TREE HEALTH - The key to good wound closure following pruning is to maintain a healthy tree through
proper watering, fertilizer application and pest control. Trees under stress from drought, over-watering, pest attack, lawn
mower, and other mechanical damage, and poor nutrition cannot successfully fight off invasion of organisms.

Advertising