MCZ Flux HYDRO User Manual

Page 5

Advertising
background image

3

1 - WARNINGS AND WARRANTY CONDITIONS

Technical Dept. - All rights reserved - Reproduction is prohibited

• Any type of tampering or unauthorised replacement with non-original spare

parts could be hazardous for the operator’s safety and relieves the company

from any civil and criminal liability.

• Many of the surfaces of the product get very hot (door, handle, glass, smoke

extraction pipes, etc.). Avoid coming into contact with these parts

without adequate protective clothing or suitable means, such as

gloves with thermal protection or “cold handle” operating systems.

It is forbidden to operate the product with the door open or the glass

broken.

The doors/covers on the appliance must remain closed when it is not

used.

• The product must be powered by an electrical system that is equipped with an

effective earthing device.

• Switch the product off in the event of a fault or malfunction.

• Accumulated unburned pellets in the burner after each “failed start-up” must

be removed before lighting again. Check that the burner is clean and positioned

properly before lighting again.

• Shut the stove down in the event of a breakdown or bad running and

contact the engineer immediately.

• Pellets must not be fed manually into the burner – this wrong

behaviour can generate an abnormal amount of unburned gas, with a

risk of explosion in the chamber.

• Accumulated unburnt pellets in the burner after a failed ignitions

must be removed before lighting.

• Failure too clean and maintain the brazier can result in improper running and

explosions within the stove. Make sure you remove and clear the holes in the

brazier and any loose encrustations every time you empty the ash from the

stove or every time you have a failed ignition.Make sure that the holes in the

brazier are never reduced in size as this will affect the safe performance of the

stove if not maintained.

• Do not wash the product with water. The water could get inside the unit and

damage the electrical insulation and cause electric shocks.

Advertising
This manual is related to the following products: