Assembly and feet adjustment, Ceramics assembly, Frame assembly (wood module) – MCZ Alpha User Manual
Page 20
INSTALLATION AND USE MANUAL
Chapter 4
page
20
Installation and assembly
Technical service - MCZ
S.p.A. all rights reserved - Reproduction prohibited
4.3.
ASSEMBLY AND FEET ADJUSTMENT
Some models require the assembly of support feet whose purpose is to
level the stove to be well-aligned and stable. For the Wood Module, the
feet also lift the structure to prevent the decorative frame from coming
into contact with the floor. Correct adjustment requires the frame to be
about 0.5 cm above the floor.
The feet are screwed into the structure base and can be installed as
illustrated and adjusted using a screwdriver.
4.4.
CERAMICS ASSEMBLY
For the assembly of ceramics for each specific wood stove model,
please see the ceramics installation manual in the latter's packaging.
Assembly instructions for the Modulo product decorative frame are
included below.
4.5.
FRAME ASSEMBLY (WOOD MODULE)
For stove frame assembly, after unpacking, remove the top of the
stove, unscrewing the four screws on the top, place the frame on the
structure and continue as indicated below
PHASE 1
Near and fit the lower frame supports in the slots on the lower part of
the stove structure.
PHASE 2
Near the frame and fit the top edge of the structure so the screws
match the holes on the structure. Secure the frame with the fastening
screws as illustrated.
After levelling the last tile, make sure the cornice is fastened
correctly to the structure of the heater, checking that the
latter is firmly anchored.
Phase 2 Match the frame to the structure as illustrated and secure using the
fastening screws and bolts
Phase 1 Fit the lower frame supports on
the lower part of the structure