Operating instructions precautionary measures – Euro-Pro MINI CANISTER WITH CADDY HV118H User Manual

Page 4

Advertising
background image

OPERATING INSTRUCTIONS

PRECAUTIONARY MEASURES

7

Debris

Screen

6. “TapClean” the Debris

Screen or rinse under

a faucet until clean.

Remember that the

Debris Screen must be

completely air dried for

24 hours before

reinstalling in the vacuum.

7. To re-assemble the HEPA filter

assembly, first insert the HEPA

filter onto the dust cup cover

making sure to push it all the way

in. Then insert the debris screen

again making sure that it is pushed

all the way up against the dust cup

cover.

8. When replacing the dust cup cover

with the HEPA filter assembly

into the dust cup, make sure that

the tab on the

dust cup cover

is fully aligned

with the tab

indentation on

the dust cup

handle otherwise

the seal will not

be complete

and the unit will not

function properly.

PLEASE NOTE: The white pleated

filter material in the HEPA Dust Cup

Filter will discolor over time -This is

NORMAL and will NOT affect the

performance of the filter. If the HEPA

Dust Cup Filter is

properly "TapCleaned”

after each use and

suction does not

return to 100%, then

we suggest that the

HEPA filter be

“TapCleaned”

vigorously until no

more dust can be

removed, then rinsed under the faucet

and allowed to air dry for 24 hours

before refitting into the vacuum. (Fig.

A) Wash once a month or when

suction appears reduced.

Fig. A

Wash once a

month or when

suction appears

reduced.

Warning: Allow 24

hours for drying

before replacing in

unit.

Changing & Cleaning the Exhaust

Filter

The exhaust filter is a washable filter but

should be replaced every three (3)

months depending on usage.

1. Remove the exhaust filter cover from

the rear of the unit.

2. Rinse the exhaust filter in

lukewarm water and dry the

filter completely. Do not use

a washing machine to rinse

the filter. Do not use a

hair dryer to dry it. Air dry

ONLY for 24 hours. Never

operate the vacuum without

the exhaust filter in place.

3. When the filter is dry, replace

into the unit and replace the exhaust

filter cover over it.

4. A severely soiled or clogged filter

should be thoroughly washed with

fresh tepid water. A mild detergent

can be used if required.

IMPORTANT:

This unit is equipped

with a motor protective thermostat. If for

some reason the vacuum cleaner should

overheat, the thermostat will

automatically turn the unit off. Should

this occur:

• Push the On/Off button once.

• Disconnect the plug from the power

source.

• Check the source of overheating

problem. (i.e. clogged hose or filter)

• If clogged hose or filter is found, unclog

the hose and replace the filter.

• Wait at least 45 minutes before

attempting to reuse the vacuum.

• After unit has cooled down for 45

minutes, plug in the cleaner and push

the On/Off button. The vacuum should

start again.

• If the vacuum still does not start,

contact customer service at

1 (800) 798-7398.

Motor Thermostat

When the Intelli-Sense Filter Monitor

TM

lights up, it means that the dust cup is full

or filter needs cleaning. You must empty

the dust from the dust cup and clean the

HEPA dust cup filter right away.

Intelli-Sense Filter MonitorTM

CAUTION

: The suction hole must be

open, free of any obstructions at all

times. Otherwise, the motor will overheat

and could become damaged.

5. Vigorously “TapClean”

the HEPA Dust Cup

Filter on a hard

surface until no more

dust is observed

falling out from

between the pleats of

the filter.

Important:

If the suction opening in the unit, the hose or the extension tubes
become blocked, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.

5.

When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.

1.

Do not operate the vacuum
cleaner to close too heaters,
or radiators.

6.

Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.

2.

Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.

7.

Do not use without dust cup filter or

exhaust filter in place.

8.

Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.

3.

Do not vacuum any liquids.

4.

Keep hair, loose clothing, fingers,

feet and all parts of body away from
openings.

2

Advertising