Meliconi Gumbody Facile Light - Manual (Page 4)

GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
C
This operation can take up to 20 minutes and should be carried out if you have not
succeeded in programming the remote control by means of the other methods.
The quickest and easiest way to programme the remote control is
by consulting the website www.gumbodylight.com .
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
1. Switch on the TV.
2. Hold down the MUTE and ON/OFF buttons together for
5 seconds until the light indicator at the top starts to
flash indicating that the remote control is being
programmed.
3. Release the keys and enter the code 0000 within 12
seconds. The light indicator flashes more quickly to
indicate that the remote control is ready for the search.
4. Point the remote control at the TV. Press and slowly
release the ON/OFF key several times, stopping when
the TV goes off.
5. When the TV goes off, press the OK key to confirm.
Three flashes indicate that the operation has been
completed correctly.
ADDITIONAL CHECK
Check that some of the other keys, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar remote
control but not the right one. In this case, repeat the search procedure starting from
point 2.
+ + + 0 0 0 0
N.B. THE LIGHT INDICATOR STOPS FLASHING
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if the end of the code search list has been reached. In this case, consult our website
www.gumbodylight.com
+
5 SEC.
10