Epson EQUITY Y14499113001 - Manual (Page 93)

This test operates by a complex process of writing, reading, and
verifying
information on every track of the hard disk, except for tracks that are
already flagged as bad tracks.
To start the test, press 3
and
then Enter. You see these messages:
Analyze Hard Disk
Read/Save/Write/Read/Restore/Read check for all
tracks...
Current cylinder is xxxx
As each track number counts down to zero.
When the analysis is complete, the program displays a complete report on
the
status
of the disk, including a table of unflagged tracks that produced
write, read errors. For a 20MB hard disk with one flagged bad track, you see
this display:
Analysis finished.
Count of tracks flagged bad
Count of tracks with write, read errors
=
Count of good tracks =
No write, read error was detected.
No data was destroyed.
Press ENTER to return to the menu.
If the program finds one bad track that is not flagged, the summary
above shows track with a write, read error, and only 2458 good tracks.
The report is then followed by a table like this:
Write, Read Error Tracks
Cylinder Head Cylinder Head Cylinder Head
237 2
Confirm to register the tracks in the Write,
Track Table as bad tracks.
Do you to register the error tracks bad txa ?
3 -7