Eclipse - Fujitsu Ten AVN2227P - Manual (Page 6)

- 6 -
Deutsc
h
English
E
spañol
Français
Italiano
Nederlands
Svenska
Antenna power supply (Blue)
Connect to the automatic-antenna control terminal of the vehicle.
Control power supply (Blue/White)
Connect the control terminal for the external amplifier, etc.
Cellular phone mute Cable (Pink)
Connect to the earth output terminal on a mobile phone.
Earth (Black)
Connect where good body earthing is available.
Vehicle speed pulse signal cable (Purple/White)
Connect to the vehicle speed pulse signal terminal.
Genuine factory steering remote control terminal
Connect to the vehicle steering remote control.
Compatible vehicle models for installation : Vehicles with voltage detection-type steering remote control.
Ask your dealer for details.
6
5
4
3
2
1
- Vehicle connections -
• • You will need to purchase the necessary component adapter cable for the vehicle so that the power supplies can
be utilised. (Contact the dealer for further details.)
• • Be sure to wrap the connection cables with plastic tape to insulate them.
Tip
Cable colours and connection points for connection cables and
3 2
Main unit connections
Front line-out terminals
Connect to the RCA connector of an external amplifier.
Rear line-out terminals
Connect to the RCA connector of an external amplifier.
Line-out terminals (Sub-woofer)
This is used for non fader output. It can be used as a sub-woofer terminal if a separate amplifier with
a low bass filter is connected.
E-LAN terminal (13P)
If connecting portable audio equipment, connect an AUX cable (sold separately) to the E-LAN
terminal.
iPod
®
connection terminal
Connect to an iPod ® connection cable (sold separately).
USB connection terminal
Connect to a USB device such as a flash drive or digital audio player.
A
B
C
D
E
F
Tip
- If installing to a vehicle with no ACC position -
• • If installing to a vehicle with no ACC position, be sure to explain the following to the customer when handing back
the vehicle.
“When getting out of the vehicle, be sure to press the [PWR] button on the main unit for 5 seconds or more
while the power is still on, and then turn off the power.” If they forget to turn off the power, the battery will be
drained.