Primare I22 integrated amplifier - Manual (Page 6)

i 2 2 u s e r g u i d e

conFiguring the i22
The I22 allows you to rename the inputs and change the offset and balance of each
input to suit the sources in your system.
r e n a m i n g a n i n p u t
You can give any input a name of your choice of
up to six characters.
To rename an input
• Select the input you want to rename.
• Press and hold down both SELECTOR
buttons for three seconds until the first
character starts flashing.
0 1 23
• Select the character you want to edit using the
SELECTOR buttons.
The selected character is shown flashing.
• Edit the character using the VOLUME
control.
You can step through the sequence A to Z, 0 to 9,
_, -, and blank. For example:
BLURAY 23
When you’ve finished editing the name:
• Press and hold down both SELECTOR
buttons for three seconds until the selected
character stops flashing.
c h a n g i n g t h e i n p u t
o F F s e t
You can adjust the relative volume of each input,
between +9 and -9.
To change the input offset
• Select the input you want to change.
• Press and hold down the upper SELECTOR
button for three seconds until the display
shows the current offset.
OFFSET 00
• Adjust the offset using the VOLUME control.
• Press the lower SELECTOR button to exit.
c h a n g i n g t h e i n p u t
b a l a n c e
You can adjust the initial balance of each input,
between 0 and -9 in either direction.
To change the input balance
• Select the input you want to change.
• Press and hold down the upper SELECTOR
button for three seconds until the display
shows OFFSET.
• Press the upper SELECTOR button again
until the display shows the current balance
offset.
BAL 00LR00
• Adjust the balance offset using the VOLUME
control.
•
Press the lower SELECTOR button to exit.