Qlima SC3331 in - Manual (Page 62)

62
J
TROUBLE SHOOTING TIPS
Malfunctions and Solutions
G
TROUBLE
Stop the air conditioner immediately if one of the following faults occur. Disconnect the power
and contact your supplier.
• Fuse blows frequently or circuit breaker trips frequently.
• Other objects or water penetrate the air conditioner.
• The remote controller won’t work or works abnormally.
• Other abnormal situations.
Problem Cause Solution
Unit does not start
Power cut Wait for power to be restored.
Unit may have become unplugged.
Check that plug is securely in wall recep-
tacle.
Fuse may have blown.
Replace fuse / reset relay / reset circuitbra-
ker
Battery in Remote controller may have
been exhausted.
Replace the battery.
Distance remote controller to receiver on
the indoor unit is more than 6 to 7 meters,
or there are obstacles in between the
remote controller and the receiver.
Shorten the distance. Remove possible
obstacles. Aim the remote controller
towards the receiver on the indoor unit.
The time you have set with timer is incor-
rect.
Wait or cancel timer setting.
Unit not cooling or
heating room very
well while air flowing
out from the air con-
ditioner
Inappropriate temperature setting.
Set temperature correctly. For detailed
method please refer to “operation with
remote control” chapter D.
Air filter is blocked. Clean the air filter.
Doors or windows in room are open. Close the doors or windows.
Air inlet or outlet of indoor or outdoor
unit has been blocked. Clear obstructions away first, then restart
the unit.
Compressor 3 minutes delay protection has
been activated.
Wait.
Defrosting of outdoor unit being perfor-
med.
Fan speed cannot be
changed
Airconditioner is in automode
Fan speed can only be changed in HEAT,
COOL and FAN mode
Airconditioner is in dry mode
TEMP. Indicator is not
shown
Airconditioner is in fan mode Temperature cannot be set in FAN mode
If the trouble has not been corrected, please contact your supplier. Be sure to inform them of the detailed
malfunctions and unit model.
4
62