Electrolux EDE 57160W - Manual (Page 21)

Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete“) ● Lint filter clogged.
● button pressed and load
volume too big.
● Load volume too big.
● Laundry insufficiently
predrained.
● Clean lint filter
● is only suitable for use
with loads of up to 3 kg!
● Reduce load volume.
● Laundry must be adequately
pre-drained.
something not working electrolux 21
Malfunction Possible cause Solution
When pressing a button, the
corresponding button flashes
several times. ● Washing protection. After the
start of the programme, the
option can no longer be set. ● Turn the programme knob to
OFF. Set the programme
again
Drying cycle ends
shortly after programme
starts. END light illuminated. ● Not enough washing loaded
or washing loaded is too
dry for selected programme.
● Select time programme or
higher drying level (e.g. EXTRA
DRY instead of STRONG).
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.
P1206
Mod. ..........
Prod. No. ...........
Ser. No. .........
Mod. .......... Prod. No. ...........
Ser. No. .........
IMPORTANT: if you call out an engineer
to a fault listed below, or to repair a fault
caused by incorrect use or installation, a
charge will be made even if the
appliance is under guarantee.
GB
Drum light does not
work ● Programme selector in OFF
position.
● Defective light bulb
● Turn programme selector to
any programme
● Replace light bulb (see next
section).
When a button is pressed, Err
appears in the multi-display. ● Washing protection. After the
start of the programme, the
option can no longer be set.
● Turn the programme knob to
OFF. Set the programme again.
125986421_gb.qxp 2007-10-05 07:51 Page 21