RISCO Group GT 600 - Manual (Page 29)

Page 28
GT 600 601 User Manual
Setting Engineer Authorisation
A User Code may be required to authorise an engineer to gain access to the system in
the event of service or maintenance schedules. The level of User Code required to
authorise the engineer to access the system is set within the User Menu that is
accessed via a Master Level Code.
Setting the Engineer Authorisation Level
1) Enter a Master User Code. The display will
show:-
2) Press NO until the display shows:-
Then press YES.
3) Press NO until the required setting is displayed:-
Master, Main and Any are user code levels. If None is selected, no user authorisation
will be required to grant engineer access to the alarm system.
4) Press YES. The display will show:-
(This option is dealt with later).
5) Press YES. The display will show:-
6) Press 0 to return to:-
Using Engineer Authorisation
A valid Authorisor code will be required to give an engineer access to the alarm
system. This may be done in two ways.
1) The engineer will enter his/her code. The display
will show:-
2) Enter a valid level of User code to grant the engineer access.
Do you want to . .
SET the System ?
Do you want to . .
Authorise Engnr ?
Engnr Authorisor
=Any
Engineer Access
is Off Ok ?
Do you want to . .
Authorise Engnr ?
01 JAN 18 : 58 : 01
Enter Authorisor
Code . . . . . .
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 28