Epson 737C - Manual (Page 18)

Epson PowerLite 737c Projector
18 - Epson PowerLite 737c Projector 2/05
Managing Projectors from a Remote
Computer
The software included with your projector lets you monitor
and control projector(s) from a remote computer. These
features are intended for use by network administrators.
❏ Use EMP Monitor to see your projectors’ status, switch
image sources, and control basic settings.
❏ Use the mail notification function to receive e-mail alerts
about possible problems.
❏ Use a network management utility running SNMP, such as
HP OpenView,
™
to manage your facility’s equipment from
a pre-existing system.
Make sure you have installed the EMP Monitor software
(included on the projector’s CD-ROM) on the computer you
want to use to monitor your projectors. (See the User’s Guide
for instructions.)
Note:
Your computer must be running Microsoft Windows XP, 2000,
Me or 98SE.
Opening and Closing EMP Monitor
To start EMP Monitor, click Start > Programs or All
Programs > EPSON Projector > EMP Monitor .
If you’ve added the program to the Startup programs folder, it
may already be open. If so, click the icon in the system tray on
the lower-right corner of your screen to display the EMP
Monitor window:
To close EMP Monitor, right-click the program icon shown
above, then select
Exit .
Registering Projectors in EMP Monitor
Before you can monitor a projector, you have to register it.
Follow these steps:
1. Open EMP Monitor. You see this screen:
2. Click Register projector . You see this screen:
3. Click Auto detect to locate projectors currently operating
on the network. Or click Manual registration and enter the
projector’s name and network address.
Note:
If Auto detect fails to find the projector, your projector may
not be connected or configured correctly for the network.
Any projectors found on the network are listed:
4. Select each projector you want to add by clicking its name
and clicking Add . When you’re done, click Close .
Click here to start EMP Monitor
Click here
Click here
Click here