RIGOL DSA875 - Manual (Page 83)

Chapter 2 Front Panel Operation RIGOL
User’s Guide for DSA800 Series 2-31
Press “Single”
Measurement status?
Single sweep mode? Single sweep mode?
Enter single sweep mode
and wait for trigger
condition
Enter single sweep/
measurement mode and
wait for trigger condition
Sweep again and wait
for trigger condition
Wait for trigger condition
and make single
measurement again
N
N N Y
Y
Y
Figure 2-10 Process of Single Sweep
Numbers
Set the number of sweeps for a single sweep. In single sweep mode, the system
executes the specified number of sweeps and the number shown on the icon in the
status bar at the left of the screen varies with the process of the sweep.
Table 2-17 Numbers
Parameter Explanation
Default 1
Range 1 to 9999
Unit N/A
Knob Step 1
Direction Key Step 1