Rose Electronics MultiStation CATx - Manual (Page 9)

MULTISTATION CATx INSTALLATION AND OPERATIONS MANUAL 5
Keyboard Commands (All models)
Command Description
Left Ctrl, Left Shift, e: Perform a cable length measurement
Left Ctrl, Left Shift,
keyboard +: Increase the video gain by 1
Left Ctrl, Left Shift,
keyboard -: Decrease the video gain by 1.
Left Ctrl, Left Shift,
keypad +: increase the video equalization by 1
Left Ctrl, Left Shift,
keypad -: Decrease the video equalization by 1
Left Ctrl, Left Shift, k Saves any changes made
(See usage note for important information)
Left Ctrl, Left Shift, i*
(See * Below)
Sends Transmitter, CPLD, and receiver firmware
version to a text editor. Firmware is reported as
follows:
Transmitter = hxxy,
CPLD = yx,
Receiver = dxxy:
Where x is a decimal digit, and y is an alphabetic
character
Left Ctrl, Left Shift, g*
(See * Below)
Send the most recent gain, equalization, cable
length, autotdr status, red, green, and blue skew
values to a text editor.
* CAUTION: DO NOT EXECUTE THESE COMMANDS WITHOUT A TEXT
EDITOR ACTIVE. A text editor such as notepad must be started and selected
prior to executing these keyboard commands. The results will be displayed in the
text editor.
Skew Adjustment Keyboard Commands (Skew Model Only)
Perform a save command (Left Ctrl + Left Shift + k) after video adjustments
have been made and prior to any non-video adjustment command.
Command Description
Left Ctrl, Left Shift, 1:
Left Ctrl, Left Shift, 2 Increase RED delay
Decrease RED delay
Left Ctrl, Left Shift, 3:
Left Ctrl, Left Shift, 4 Increase Green delay
Decrease Green delay
Left Ctrl, Left Shift, 5:
Left Ctrl, Left Shift, 6 Increase BLUE delay
Decrease BLUE delay