Rose Electronics VISTA L-SERIES - Manual (Page 39)

Vista L-Series Installation and Operations Manual 33
Video fuzzy
 Cable too long or wrong type. Use coax cable for high resolution.
Mouse does not move
 The Vista is turned off after or not connected when CPU was booted or
the application using the mouse was run. Exit and re-enter application
or operating system using mouse or issue reset command.
 PS/2 mouse was not connected when the Vista was powered up or the
mouse was disconnected and reconnected. Issue the reset command.
 Mouse translation set incorrectly.
Video not synchronized or wrong color
 The cable may be loose, reseat cable.
 Wrong CPU cable used. If you have a 9515, 9517, 9518, XGA mono or
similar monitor you must use special cables or adapters.
 Cable is defective; try using cable from another CPU if problem goes
away cable is defective.
 Port on the Vista is defective; try using another port on the Vista. If
problem goes away port is defective.
Cannot remember the configuration or access password.
 Call Rose Electronics Technical Support for instructions.