Extron Electronics RGB 160 - Manual (Page 8)

RGB 160xi and RGB 164xi • Controls and Installation
Controls and Installation, cont’d
2-6
Under desk mounting
Mount the interface under a desk or in a podium, using
an optional Extron MBU 125 Under-desk mount kit
(part #70-077-01) as follows:
1
. Attach the mounting brackets to the interface using
four machine screws supplied with the mounting kit
(figure 2-6).
Figure 2-6 — Attaching the under desk brackets
2 . Using the not-to-scale template at the back of this manual
or the device with mounting brackets installed to guide
you, mark the four screw holes on the underside of the
surface to which you are mounting the interface.
3 . Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6 mm) deep, where marked.
4 . Using the four wood screws provided, attach the brackets
under the mounting surface (figure 2-7).
Figure 2-7 — Securing the interface to the surface
RGB 160xi and 164xi • Controls and Installation
Through desk mounting
Mount the interface through a desk or table, as follows:
1
. Attach the mounting brackets to the interface using four
machine screws and washers (supplied with the mounting
kit), as indicated in figure 2-8.
Figure 2-8 — Attaching the through desk brackets
2 . Using the not-to-scale template at the back of this manual
to guide you or the device with mounting brackets
installed to guide you, mark the four screw holes on the
underside of the surface to which you are mounting the
interface.
3 . Cut the hole.
4 . Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6 mm) deep, where marked.
5 . Using the four wood screws provided, attach the brackets
to the mounting surface.
2-7