Epson 2000 - Manual (Page 30)

If you installed an optional video card, follow the guidelines
below to select the correct adapter type.
Video display type options
Select If
EGA/VGA You connected your monitor to the built-in VGA port or you
installed a VGA or enhanced graphics adapter (EGA) card
CGA40* You installed an optional color graphics adapter set to
40-column color graphics adapter (CGA) mode
CGA80* You installed a CGA or a multi-mode graphicsadapter
(MGA) attached to a color monitor
MONO* You installed a monochrome display adapter or an MGA
attached to a monochrome monitor
* For these options, you must change jumpers J1 and J2 on the system board
to the OFF position. See Chapter 3 for information on setting jumpers
Setting Keyboard Options
Two options in SETUP allow you to control keyboard settings.
The Keyboard option allows you to disable the built-in
keyboard connector.
The NumLock on at boot option determines the initial state of
the Num Lock function when you turn on or reset your system.
When Num Lock is off, the keypad controls cursor movement.
If Num Lock is on, the keypad types numbers.
Select YES to set the Num Lock function on when the system
starts or NO to leave it off.
Setting Up Your System 1-15