Purdy AND262HS - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 6/12/07
AND262HS
Ultra Bright LED Lamps: Type 3
Weight: 0.14 g Unit: mm
AND262HS
InGaAlP Red Light Emission
T-1 Package (3 mm)
Features
• High efficient red LED
• Peak wavelength (
λ p = 632 nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current: 1-20 mA recommended
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
50 mA
Reverse Voltage V
R 4 V
Power Dissipation P
D 120 mW
Operating Temperature Range T
Opr
-25 to 85 °C
Storage Temperature Range T
Stg
-25 to 100 °C
Precaution
Please be careful of the following:
1. Soldering temperature: 260°C max
Soldering time: 5 sec. max
Soldering portion of lead: up to 1.6 mm from the body of the device
2. The lead can be formed up to 5 mm from the body of the device without forming stress.
Soldering should be performed after the lead forming.
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 2.0 2.4 V
Reverse Current I
R
V
R
= 5 V – – 50 µA
Luminous Intensity I
V
I
F
= 20 mA 400 630 – mcd
Peak Emission Wavelength λ
P
I
F
= 20 mA – 632 – nm
Spectral Line Half Width ∆ λ I
F
= 20 mA – 20 – nm
Dominant Wavelength λ d I
F
= 20 mA – 624 – nm
Full Viewing Angle θ I
V
= 1/2 Peak – 10 – degree
Product specifications contained herein may be changed without prior notice.
It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product.
• RoHS Compliant