Epson C82314 - Manual (Page 49)

EXAMPLE: &%Z64,1 Specifies all printing performed using paper from the
manual feed slot be printed in portrait orientation.
COMMAND 65: CHARACTER SET SELECTION
Enables the user to make a special selection of the ASCII character set that is
used in the conversion from EBCDIC (SCS/LU1) or DSC (LU3) to ASCII. This
is the character set that the printer uses in printing. It must be selected at the
printer by using the front panel or dip switches of the printer. Changing the
protocol selection in Command 60 automatically changes the character set as
required. However, Command 65 can override the automatic selection.
VALUE DESCRIPTION
1 Roman 8 character set
* 2 Code Page 850 character set
NOTES: The character set substitutions defined in Commands 70 and 71 must
be adjusted if the ASCII character set is changed. All previously
defined substitutions are lost from NV memory when the character set
selection is changed.
Refer to the character set summary tables at the end of the self test to
confirm which ASCII character is printed for each of the 3270 hex
codes. Both the EBCDIC and DSC tables are provided.
EXAMPLE: &%Z65,2 Selects the Code Page 850 character set
COMMAND 70: OVERWRITE EBCDIC (SCS/LU1) TRANSLATION TABLE
Custom substitutions defined by this command and stored in NV memory are
written into the EBCDIC (SCS/LU1)-to-ASCII translation table.
VALUE DESCRIPTION
xx The hex location in the EBCDIC table that sends the following
ASCII hex sequence.
YY The ASCII hex sequence that is overwritten in the EBCDIC
translation table.
A-25