Warmer drawer, Warmer drawer stand-alone installation – Electrolux EW27WD55GS User Manual
Page 2
Warmer Drawer
EW27WD55G S
High standards of quality at Electrolux Major Appliances mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
USA
•
250 Bobby Jones Expressway
•
Augusta, GA 30907
•
1-877-4electrolux (1-877-435-3287)
•
electroluxappliances.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
electroluxappliances.ca
EW27WD55G 01/08
© 2008 Electrolux Major Appliances, NA
Printed in the U.S.A.
27" Warmer Drawer Specifications
•
Product Weight – 55 Lbs.
•
Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.45 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded for
safe operation.)
•
Amps @ 120V = 3.75 Amps
•
Recommended Circuit Breaker – 15 Amps
•
60" electrical cable supplied.
•
Full plywood base required, capable of supporting 100 Lbs.
•
Base must be level and cabinet front must be square.
•
Warmer Drawer can be used alone, or is approved to be used
in combination with any Electrolux Wall Oven. (Refer to Combination
Installation Specifications and drawing on this page.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
27" Warmer Drawer / 27" Wall Oven Combination Specifications
•
To support Wall Oven when using in combination with Warmer Drawer,
two 3"-wide x 3/4" thick planks must be installed as a base, capable of
supporting 150 Lbs. Do NOT use full base, since planks are necessary
to allow for proper air displacement.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
Warmer Drawer Stand-Alone Installation
23
5
/
8
" min.
24" max.
4
1
/
2
" min.
required
distance
to floor
9
7
/
8
" min.
10
1
/
4
" max.
25
1
/
2
" min.
25
3
/
4
" max.
Full plywood
base required to
support 100 lbs.
Overall depth with drawer fully extended
(includes handle) – 45"
1
3
/
4
"
23
3
/
8
"
26
5
/
8
"
27"
11
1
/
4
"
Power cord
location (right
center rear)
Two 3" wide
x
3
/
4
" thick
planks must be
installed, capable
of supporting
150 lbs.
9
7
/
8
" min.
10
1
/
4
" max.
1
1
/
2
"
min.
*Critical dimension –
MUST be applied
**Electrical junction
box for Wall Oven
must be lower than
the Warmer Drawer
cutout
†
Maximum height
depends on critical
dimension (11
5
/
8
")
3"
max.**
Electrical
junction box
location
25
1
/
2
" min.
25
3
/
4
" max.
Bottom
of oven
cutout
11
5
/
8
"
min.*
23
5
/
8
" min.
24" max.
27
1
/
8
" min.
4" x 4"
opening
to route
armoured
cable
27
1
/
4
"
min.
28
5
/
8
"
max.
1
3
/
4
"
min.
†
27" Warmer Drawer / 27" Single
Wall Oven Combination Installation