EverFocus EDSR100M - Manual (Page 35)

MENU
Note: Alarm Connectors (DB-15)
PIN # NAME PIN # NAME
1 GND 9 GPOUT
2 ALARM 10 DISK_FULL
3 RECIN 11 VD_LOSS
4 NC1 12 VCR_SW
5 NC2 13 ALM_NC
6 ALMRST 14 ALM_NO
7 GPIN 15 ALM_COM
8 GND
The alarm connector, figure 1, is used to provide one
sensor alarm input for each camera input.
For easy operation, an alarm extension board,
figure 2, is provided to connect to the alarm
connector.
Each alarm input requires two wires, one wire
connects to the desired alarm input pin, the
second wire connects to the multiplexer
ground. The alarm signal assignment is shown
at the following table, table 1.
9 15
1 8
<Figure 1>
<Table 1>
<Figure 2>
PSR1D0080A
8 7 6 5 4 3 2 1
9 10 11 12 13 14 15
22