Epson 3010E - Manual (Page 45)

Making Detailed Adjustments
45
3D Setup
Use this menu to adjust 3D brightness, the 3D display format and other 3D settings.
Note: You should only adjust the 3D Format and Inverse 3D Glasses settings if 3D images aren’t
displaying correctly. Changing these settings unnecessarily may cause problems with 3D
projection.
■ 3D Display
Enables or disables 3D mode. You can also change this setting by pressing the 2D/3D
button on the remote control.
■ 3D Format
Use this setting to select the 3D format supported by your video device. In most cases, the
projector will correctly detect the 3D format when this option is set to
Auto . You should
only select the 2D , Side by Side , or Top and Bottom formats when your projector
doesn’t properly display 3D images. See your video source documentation for
information on which mode to select.
■ 3D Brightness
Adjusts the brightness of 3D images. Select the Medium or High settings if the 3D
display is too dark.
Note: This setting is not available when 3D Format is set to Auto.
■ Inverse 3D Glasses
Reverses the timing for the left and right shutters on the 3D active shutter glasses. Only
enable this function if 3D images are not displaying correctly.
Note: This setting is not available when 3D Format is set to Auto.
■ 3D IR Emitter
Select External if you’ve connected an external 3D IR emitter (see “Optional
Accessories” on page 10 for ordering information).
Signal > 3D Setup > 3D Display
Signal > 3D Setup > 3D Format
Signal > 3D Setup > 3D Brightness
Signal > 3D Setup > Inverse 3D Glasses
Signal > 3D Setup > 3D IR Emitter
pl3010_3010e_UG.book Page 45 Wednesday, September 7, 2011 6:28 PM