Euro-Pro EP8020 - Manual (Page 8)

5. STEAM:
A. TO EMPTY/RELEASE STEAM FROM THE GENERATOR:
1. Press Iron On/Off Rocker Switch (4) into the “ON” position.
2. Press the “Steam On/Off Rocker Switch (1) into the “Off”
position.
3. Release all remaining steam in the steam generator by
pressing the “Steam Button” (a) on the iron.
4. Press the Iron ON/OFF Rocker Switch (4) into the “OFF”
position.
5. Unplug the appliance from the wall outlet. Allow it to cool a
minimum of 5 minutes. Make sure that both the Iron
ON/OFF Rocker Switch (4) and the Steam ON/OFF Rocker
Switch (1) are in the “OFF” position.
B. FILLING/REFILLING THE REMOVABLE WATER TANK (9) :
The tank can be filled/refilled using a bottle or similar object, or by taking it off the base
altogether. To fill it using a bottle, just open the rotating cap (10) and then replace the rotating
cap (10) after you have filled the water tank.
To fill/refill the removable water tank (9) by removing the tank from the base, proceed as
follows:
1. Release the Locking Device (8) on the removable water tank (9) and remove the water tank
by lifting it up.
2. Open the Rotating Cap (10) and fill with tap or demineralized/distilled water (maximum
capacity 2 1/2 cups/625 ml).
3. Re-close the Rotating Cap (10) and put the removable water tank (9) back on the Steam
Base Tank (7), pushing is down until the locking device (8) clicks.
4. Your appliance is now ready to use.
C. WHEN TO REFILL THE WATER TANK/STEAM GENERATOR:
For best results, refill water tank/steam generator to maximum before every usage, when
steam power is recognized lower while in use or when Water Level Indicator Light (3) goes
“On”. Follow the water filling/refilling instructions above.
6