DE DIETRICH DHD1190B - Manual (Page 22)

22
Standard configuration
If two cookerhoods-radiocontrol system are installed in the same room or in the immediate vi-
cinity, each system may affect the operation of the other, due to the fact that they have the same
code. Therefore it will be necessary to change the code of one of the radio controls.
warning :
The battery should be replaced every yearto guarantee the optimal range of the transmitter. To
replace the exhausted battery, take the plastic lid off, remove the battery and replace it with a
new one, observing the correct battery polarities. Used batteries should be discarded in special
collection bins.
Emergency switch: Emergency switch:
In the event of failure of the remote control, press the emergency switch placed in the top side
of the cooker hood to turn the appliance off. (fig. 17).
If you want to create a new set of codes, proceed as follows: press and hold the UP, STOP and
DOWN buttons simultaneously for 2 seconds. Afterthe LEDS light up, press the UP and DOWN
button swithin 5 seconds. The LEDS will flash 3 times to indicate that the process is completed.
warning : This procedure deletes all previously stored codes.
Learning the new transmission code:
After changing the transmission code on the radio control, the cooker hood electronic control
unit must be made to set the new code as follows: press the main Power Off button on the
cookerhood and then restore power to the electronic control unit. Within the next 15 seconds,
press the Light button . This will ensure the control unit is synchronized with the new code.
warning :
To tune in the remote control when commissioning the cooker hood and when changing the trans-
mission code, keep the light key of the remote control pressed for at least 5 seconds.