Echo CS-352 - Manual (Page 10)

10 CS-352
DECALS
Locate these safety decals on your unit. Make sure
the decal is legible and that you understand and fol-
low the instructions on it. If a decal cannot be read, a
new one can be ordered from your ECHO dealer.
WARNING!! Read and follow all
safety precaution in the instruction
manual. Failure to follow
instructions could result in serious
personal injury.
CS-352 rEPLaCEMEnT Bar anD CHain
GUIDE BAR* CHAIN*
PART NO. PART NO. LINKS
12” 12A0CD3745 91PX 45
14” 14A0CD3752 91PX 52
16” 16A0CD3757 91PX 57
Note: There may be other replace-
ment components for achieving
kickback protection. For details,
please refer to the chain and bar
combination sheet shown in the
instruction manual.
E
mission
D
ata
an Emission Control Label is located on the en-
gine. (This is an EXAMPLE ONLY, information on
label varies by engine FAMILY).
E
mission
C
ontrol
(
Exhaust & EvaporativE
)
EPA 2010 and Later and/or C.A.R.B. TIER III
PrODUCT EMiSSiOn DUraBiLiTY (EMiSSiOn COMPLianCE PEriOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying
the engine emissions output meets applicable emissions regulations, provided that approved mainte-
nance procedures are followed as listed in the Maintenance Section of this manual.
The emission control system for the engine is EM (en-
gine modification) and, if the second to last character
of the Engine Family on the Emission Control Informa-
tion label (sample below) is “C”, “K”, or “T”, the emis-
sion control system is EM and TWC (3-way catalyst).
The fuel tank/fuel line emission control system is EVAP
(evaporative emissions). Evaporative emissions for
California models are only applicable to fuel tanks.