DE DIETRICH LZ9619E1 - Manual (Page 8)

Installation
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not touch
the wall or other kitchen units.
Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the floor.
Water inlet
Connect the water inlet hose to a tap with a
3/4” thread.
The other end of the inlet hose which
connects to the machine can be turned in
any direction. Simply loosen the fitting,
rotate the hose and retighten the fitting,
making sure there are no water leaks.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
P0021
P1088
P1051
Water drainage
The end of the drain hose can be positioned
in three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked. Run it
along the floor; only the part near the
drainage point must be raised.
P0023
P0022
GB
8