Electrolux 67670KF-N - Manual (Page 23)

23
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
3
If the appliance has been wrongly operated, the visit from the service
technician or dealer may not take place free of charge, even during the
warranty period.
Display is switching be-
tween two heat settings Power management is re-
ducing the power of this
cooking zone See the section “Switching
the power function on and
off”
flashes Unsuitable cookware Use suitable cookware
No cookware on the cook-
ing zone Place cookware on the
cooking zone
The diameter of the bot-
tom of the cookware is too
small for the cooking zone Move onto a smaller cook-
ing zone
Use suitable cookware
is lit Overheating protection for
the cooking zone has been
triggered Switch off the cooking
zone. Switch the cooking
zone on again
Safety cut-out has been
triggered Switch off the cooking
zone. Switch the cooking
zone on again
and number are dis-
played
Electronics fault Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house’s wir-
ing system)
If after switching on again,
is displayed again, call
the customer service de-
partment
and minus are displayed Light rays that are too
strong on the control pan-
el, for example bright sun-
light
Briefly shade the control
panel, for example with
the hand Acoustic signal
sounds, appliance switches
itself off Switch appliance
on (again)
Problem Possible cause Remedy