Amprobe RLD-1 Refrigerant-Leak-Detector - Manual (Page 16)

9 10
�
- EMC: Conforms to EN61326-1. This product complies
with requirements of the following European Community
Directives: 89/ 336/ EEC (Electromagnetic Compatibility) and 73/
23/ EEC (Low Voltage) as amended by 93/ 68/ EEC (CE Marking).
However, electrical noise or intense electromagnetic fields in the
vicinity of the equipment may disturb the measurement circuit.
Measuring instruments will also respond to unwanted signals
that may be present within the measurement circuit. Users
should exercise care and take appropriate precautions to avoid
misleading results when making measurements in the presence of
electronic interference.
MAINTENANCE AND REPAIR
If there appears to be a malfunction during the
operation of the meter, the following steps should be
performed in order to isolate the cause of the problem.
1. Check Batteries or replace batteries.
2. Review the operating instructions for possible
mistakes in operating procedure.
Except for the replacement of the battery, repair of the
meter should be performed only by a Factory Authorized
Service Center or by other qualified instrument service
personnel.
The front panel and case can be cleaned with a mild
solution of detergent and water.
Apply sparingly with a soft cloth and allow to dry
completely before using. Do not use aromatic
hydrocarbons, Gasoline or chlorinated solvents for
cleaning.
�
WARNING!
The detergent or isopropyl alcohol might damage
the sensor, please keep them from the sensor
through the process.