Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 10)

LSI Corporation
- 10 -
MegaRAID CacheVault Flash Module 02 Quick Installation Guide
March 2012 MegaRAID CacheVault Flash Module 02 Quick Installation Guide
Attaching the CVFM02 Module to a RAID Controller and Connecting It to a CVPM02 Module
on a Remote Mount Board
Installing the Remote Mount Board in the System
Follow these steps to install the remote mount board in the computer.
1. With the power to the chassis still turned off and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCI Express slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Secure the remote mount board to the computer chassis with the bracket screw.
Figure 7 Installing the Remote Mount Board
5. Reinstall the computer cover, and reattach the power cords.
NOTE Some PCI Express slots support only PCI Express graphics cards; if a RAID controller is installed in
one of these slots, the controller will not function. Refer to your computer documentation for information
about the PCI Express slot.
Bracket
Screw
Press
Here
Press
Here
3_00895-00