Avago Technologies MegaRAID SAS 9240-4i User Manual
Page 15
LSI Corporation
- 15 -
MegaRAID SAS Device Driver Installation User Guide
June 2014
Windows Driver Installation
Secondary Storage on the MegaRAID Controller with the Windows 2003 OS
Perform the following steps:
1.
At the question Can Windows connect to Windows Update?, select the answer: No, not this time.
2.
Click Next.
3.
Select Install from a list or specific location.
4.
Click Next.
5.
Select Search for the best driver in these locations.
6.
Click the Include this location in the search check box.
7.
Uncheck Search removable media.
8.
Click Browse.
9.
In the Browse for Folder window, locate and click on the previously created folder with the extracted driver files.
10. Click OK.
11. Click Next.
12. Click Install.
The Update Driver Software wizard displays the message The software for this device has been
successfully
installed.
13. Reboot the system.
If you do not install the MegaRAID driver at boot time, the MegaRAID driver is added or updated in the Windows
environment by using Device Manager. Many methods exist to start Device Manager, including one general method
for all supported variants of the Windows 2003 OS.
Perform the following steps:
1.
Select Run > Search > devmgmt.msc > enter key.
In Device Manager, a MegaRAID controller with no driver appears under “Other devices” as a RAID controller.
2.
Right-click and select RAID Controller.
3.
If the device is not shown, double-click Storage controllers to expose any detected controllers supported by an
existing driver.
4.
If you locate the MegaRAID controller, right-click the controller.
The driver installation steps for the Windows 2003 OS the same no matter where the device was found.
5.
Click Update Driver Software.
6.
Click Browse My Computer to search for driver software.
7.
Click the Browse button.
8.
In the Browse for Folder window, locate the previously extracted driver files from the local boot disk, CD, DVD,
network, or USB device.
9.
Click OK.
10. Click Next.
11. Click Install.
The Update Driver Software wizard shows the message The software for this device has been
successfully installed.
12. Reboot the system.