Reinstalling the controller in the computer – Avago Technologies MegaRAID SAS 9260-16i User Manual
Page 13
LSI Corporation Confidential
|
August 2010
Page 13
MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation Guide
Connecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller
Figure 7: Connecting the LSIiBBU08 Remotely to the Interposer Card
Reinstalling the Controller in the
Computer
Follow these steps to install the RAID controller in the computer.
1. With the power to the chassis still turned off, and the power cords unplugged, make
sure the chassis is grounded and has no AC power.
2. Insert the RAID controller in a PCI Express slot on the motherboard, as shown in
.
NOTE: Some PCI Express slots support only PCI Express graphics cards; if a RAID
controller is installed in one of these slots, it will not function. Refer to your computer
documentation for information about the PCI Express slot.
3. Press down gently but firmly to seat the card correctly in the slot.
85039-08