Epson 503c - Manual (Page 51)

Fine-tuning the Projector 45
5. Click and drag using the Enter button to select the area of the
image you want to use. Once you have selected the entire area,
press
Enter .
6. When you see the message “Do you use this image?” select Yes
and press Enter . If you want to change the area selected, select
No , press Enter and repeat steps 4 through 6. You see a message
like the one at the right.
7. Use the Enter button on the remote control to select a zoom rate
(display size), and then press Enter .
8. When you see the message “Do you save the user logo?,” select
Yes and press Enter . Saving the logo may take a few minutes. Do
not use the projector or other sources (computer, video, speaker,
etc.) while the logo is being saved.
9. When you see the message “Saving the user logo is completed,”
press Esc or Menu .
Selecting When the Image Displays
After your image is saved, you can set it up as the no-signal message
and/or the screen that’s displayed when you press the
A/V Mute
button.
1. Press the Menu button to display the main menu (if not already
displayed).
2. Use the Enter button to highlight Setting .
3. Press Enter to select the Setting menu.
4. Use the Enter button to highlight No-Signal Msg .
5. Use the Enter button to select Logo . This sets your image as the
screen displayed when the projector is not receiving a signal.
6. If you want to set up your image as the A/V Mute display, use the
Enter button to move down to A/V Mute .
7. Use the Enter button to select Logo . This sets your image as the
screen displayed when you press the A/V Mute button.
8. When you’re finished, press Esc or Menu .
note
You can also set up your
image as a startup screen.
Use the Advanced menu to
enable the startup screen; see
page 48.