Epson 503c - Manual (Page 83)

Appendix A: Connecting to Additional Equipment 77
Connecting to a Desktop Macintosh
You can connect the projector to any desktop Macintosh. This section
includes instructions for the following:
■ Connecting the computer video cable
■ Connecting the mouse cable (if you want to use your remote
control as a mouse)
■ Connecting an optional audio cable (if you’ll be projecting with
audio)
When you connect the projector to a desktop Macintosh, you cannot
view your display on the Macintosh monitor.
Follow the steps in each section for the cables you need to connect.
Before beginning, turn off the projector and computer if they are on.
Connecting the Computer Cable
Follow these steps to connect the computer cable. You may not need
to use the adapter as shown.
1. Disconnect the monitor cable from the video port on the back of
the Macintosh.
2. Connect one end of the computer cable to the projector’s
Computer port, as shown.
3. Connect the other end of the computer cable to the video port on
the Macintosh.
note
Macintosh configurations
vary. See your computer
manual for the location of the
ports needed to connect your
projector. Older models may
require a Macintosh adapter,
which you may purchase
from EPSON; see page 8.
Macintosh
adapter (if
needed)