Mpman CSU622PLL - Manual (Page 8)

For Customer Use
Enter below the Serial No. which is located
On the bottom of the cabinet. Retain this
Information for future reference.
Mode No.
Serial No.
EN-2
PREPARATION FOR USE
Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not
remove any labels located on either the back or button cabinet of the unit.
* Press the CD door OPEN Button to open the CD compartment door. There is a white card in the CD
compartment which is intended to prevent the CD pickup from moving during shipment of the product,
Remove this card from the CD compartment before use.
, , , , , , , ,
Batteries (not included)
Open the battery compartment and insert eight batteries, type LR14, UM-2 or C-cells,
(preferably Alkaline) with the correct polarity as indicated by the + and - symbols
inside the compartment
Batteries contains chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electrolyt leakage and will corrode the compartment or
cause the batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of the same
type for the set.
When inserting new batteries, do not try to mix old batteries with new ones.
Remove the batteries if the set is not be used for a long time.
Using AC power
1.Connect the power cord to the AC inlet and the wall outlet. the power supply is now socket
connected and ready for use.
2.To switch off completely, unplug the power cord from the wall outlet.
Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.