Mpman ICR300 - Manual (Page 2)

4
5
8
TO TURN UNIT ON TO TURN UNIT OFF
SET SOUND QUALITY *Factory setting is “HP”
There are 4 recording quality for your choice,
For best sound quality, select HP(High Play); 5.5 hours recording.
For good sound quality, select MP(Medium Play); 8 hours recording.
For normal sound quality, select SP(Standard Play); 16 hours recording.
For longer recording time, select LP(long Play); 50 hours recording.
SET TIME AND DATE
When batteries are insert, 06y 1M 01D 12:00:00 will be on LCD.(Date mode.)
SET MIC SENSITIVITY SET VOICE
ACTIVATE(VOX)
SELECT A FILE FOLDER. (A,B,C,D)
There are 4 file folders(A,B,C,D)for your recording.
Each file folder can store 99 messages, and you can save 396 messages total
on the unit.
Use SD card. HOLD and Volume
Note : When you use SD card for playing/Recording, you must set SD card “On” each time
after inset SD card, (SD card i-con is on LCD.) *If there is no SD card in unit, it cannot be
“On” for SD card.
NORMAL RECORDING
*To turn LCD on, press PLAY
key once.(Time & Date on LCD/
Date mode.)
*Then, To power unit on, press
MODE key once.(ICR mode is
n LCD). o
To turn unit off, At ICR mode, press
and hold PLAY key more than
2seconds. LCD will be Displayed
time & date. (Date mode.)
* Unit will be off LCD after 60
seconds without any action.(Auto
ower off.) p
1
MODE
2
MODE
To enter Set Mode. When ICR
mode,. press and hold MODE key
more than 3 seconds.
SET is displayed on LCD. Use (←)or
(→) key to select 1 recording quality.
To confirm, press Play key then
press Mode key to back.
To confirm the setting, press
PLAY key and then Press
MODE key to back.
To choose setting item,
First, enter Set Mode.
Then, use (↑)or(↓)key first to
select mode, then use (←)
or(→)key further setting.
OPERATION (CONTINUED)
1 2
MODE
Y
D M
To enter SET mode, press and
hold MODE key, then press
down key (↓)till time and date
on LCD.
①Select Year(Y) and set with
(←) or(→).Then press PLAY key
to confirm. ②Select month(M)
and set with ( ← ) or( → ).Then
press PLAY key to confirm.
③Select Date(D) and set with
(←) or(→).Then press PLAY key
to confirm. ④Select Hour
and set with (←) or(→).Then
press PLAY key to confirm.
⑤Select Minute and set with (←)
or(→).Then press PLAY key to
confirm.
*Press MODE key to back.
In set mode, press down Key(↓)
till MIC setting. Then press
(←)or(→)key to LOW or HI. Press
PLAY key to confirm then press
MODE
In set mode, press down key(↓)
till VOX appeared on LCD. Set
VOX on or off with (←)or(→)key.
Press PLAY key to confirm the
key to
back.
key to back.
*LOW for sounds near by unit;
*Hi for sounds far from unit.
*Factory setting is “HI”
setting then press MODE
*Factory setting is “Off”
OPERATION(CONTINUED) OPERATION(CONTINUED) OPERATION(CONTINUED)
7 NOTE:
Each time you record a
message, the unit will assign
number automatically
The file number will be
shown on LCD.
*If the units is full, FULL will be
appeared on LCD. Delete
same messages and you can
ecord again. r
B
A
C
D
Power on unit, press FILE/REP
key to select 1 to record
message.
*Factory setting is “A”
HOLD
VOL
SD car d: ON/ OFF
To use SD card,
insert SD card first. Long press
MODE key to enter Set Mode.
Then use (↑)or (↓)key
till
logo appeared on LCD.
Select ON with (←)or(→)key.
Press PLAY key to confirm and
press MODE key to back. SD
card
is recording storage media.
HOLD key and VOL key on right
side on unit.
*If unit doesn’t work, check
HOLD key off.
*If there is no sound even unit is
working, volume up slowly.
OPERATION (CONTINUED)
1 2 B
A
C
D
Make sure VOX set OFF. Turn
unit on, and select sound quality
(HP,MP,SP,LP)
*Factory setting is “Off”.
Select a File Folder to record
with FILE/REP key
*Factory setting is “A”
A
SP
3 4
A
SP
REMAI N
To see remain recording time.
Press PLAY/STOP button while
Recording. ’REMAIN’ appeared
and remain recording time on
LCD for 3sec.
*While recording, press II/DEL
key for pause, and press the key
again to start recording.
Power on unit(ICR mode), and
press REC/STOP key once. LED
light on and start recording. New file
# & recording time are on LCD.
To stop recording, press
REC/STOP
Key again. *When you use external
microphone, put it into mic. Jack on
unit.
NOTE :
* Recording level is automatically sets by unit..
* To record another message, simply press REC/STOP key, Message(file) number
will increase one by one.
* For normal voice recording, distance of 5-9 inches is appropriate.
Do not remove the batteries while recording or otherwise interrupt the recording
process. Doing so may result in lost or damaged recording files. Unit will take a
few minutes to resume normal operations.(the display will read “LOAD” until normal
function resumes.).In order to protect your voice recordings, it is good practice to
regularly save backup copies or your recordings(see the PC Connection & Software section
of this manual for more information).