ProSoft Technology MVI56-S3964R User Manual

ProSoft Technology Relay

Advertising

This manual is related to the following products:

MVI46-S3964R MVI69-S3964R MVI69-PDPS MVI69-DNPSNET MVI69-EGD

Table of contents

Document Outline

Start Here
- System Requirements
- Package Contents
- Install ProSoft Configuration Builder Software
To install ProSoft Configuration Builder from the ProSoft We
To install ProSoft Configuration Builder from the CD-ROM
- Setting Jumpers
- Install the Module in the Rack
- Connect your PC to the Processor
- Open the Sample Ladder Logic
  - To Determine the Firmware Version of your Processor
  - Select the Slot Number for the Module
To change the slot number
- Configuring RSLinx
If RSLogix is unable to establish communication with the pro
- Download the Sample Program to the Processor
To download the sample program from RSLogix 5000 to the Cont
- Connect your PC to the Module
Installing and Configuring the Module
- Installation Instructions
  - Module Data Object
- ProSoft Configuration Builder
  - Set Up the Project
    - Adding a Project
To add a project to an existing project file:
- Adding a Module
To add a module to your project:
To add a module to a different location:
- Set Module Parameters
To rename an object:
- Module Entries
To configure module parameters
- Comment Entries
To add comments to your configuration file:
- Printing a Configuration File
To print a configuration file:
- [Module]
  - Module Name
- [Backplane 56]
  - Block Transfer Size
  - Status Interval
- [3964R Port x]
  - Enable
  - Baud Rate
  - Parity
  - Data Bits
  - Stop Bits
  - RTS On
  - RTS Off
  - Use CTS Line
  - Swap
  - Priority
  - Protocol
  - ACK Delay
  - Setup Attempts
  - Transmit Attempts
- Download the Project to the Module
To Download the Project File
Ladder Logic
- Introduction
  - Explanations About the Example Programs
  - The 3964R Communication Program
- Commands
  - 9998 Warm Boot
  - 9999 Cold Boot
Diagnostics and Troubleshooting
- Reading Status Data from the Module
- LED Status Indicators
  - Clearing a Fault Condition
  - Troubleshooting
Reference
- Product Specifications
- Functional Overview
- Cable Connections
- Reference Documents
Siemens
- Status Data
- Error Codes
Support, Service & Warranty
- How to Contact Us: Sales and Support
- Return Material Authorization (RMA) Policies and Conditions
  - All Product Returns
- Procedures for Return of Units Under Warranty
- Procedures for Return of Units Out of Warranty
  - Un-repairable Units
  - Purchasing Warranty Extension
- LIMITED WARRANTY
Index