Mount and remove your system easily – ProSoft Technology 3170-PDP User Manual
Page 12
3170-PDP ♦ FLEX Platform
Overview of FLEX I/O and Your PROFIBUS Adapter Module
FLEX I/O™ PROFIBUS Adapter
Page 12 of 152
ProSoft Technology, Inc.
August 23, 2007
terminal base - contains a terminal strip to terminate wiring for two- or three-
wire devices
I/O module - contains the bus interface and circuitry needed to perform
specific functions related to your application
For information on how communication occurs over the FLEX I/O system
backplane, refer to Chapter 2.
You can horizontally or vertically mount the FLEX I/O system on a standard DIN
rail. The adapter and terminal base easily snap on the DIN rail by hand. Refer to
the installation instructions shipped with these components.
2.2
Mount and Remove your System Easily
Screw holes are also provided to horizontally or vertically panel-mount your
system in an enclosure. To panel-mount your FLEX I/O system, use the optional
mounting kit (1794-NM1).
An example of a DIN-rail mounted system is shown below.