ProSoft Technology 5301-MBP-ASCII - Manual (Page 38)

Serial Port Modbus Error and Status Data MBP ♦ ProLinx Gateway
Protocol Manual Modbus Plus
Page 38 of 52 ProSoft Technology, Inc.
May 12, 2011
6.3 Master Command Status
The following table lists the registers that contain Master Command Status error
codes for each device. The register address range is 4170 to 4369.
Status Register Description
4170 Master Command Status: #1
4171 Master Command Status: #2
4172 Master Command Status: #3
4173 Master Command Status: #4
4174 Master Command Status: #5
- ----
4368 Master Command Status: #199
4369 Master Command Status: #200
6.3.1 Master Command Status Error Code Definitions
The following error codes may be present in the Master Command Status error
code registers listed in the previous table. The following table lists each of the
codes and associated definition.
High Byte Low Byte Description
0x00 Normal: Driver will reset when processing commands.
0x01 Command has completed successfully.
0x02 Routing Errors
0x01 No response received: Is addressed unit online?
0x02 Program access denied.
0x04 Exception response received.
0x08 Invalid node type in routing path.
0x10 Slave rejected the Modbus command: Invalid input path?
0x20 Initiated transaction forgotten by slave.
0x40 Unexpected master output path received.
0x80 Unexpected response received.
0x04 Configuration Errors
0x01 Invalid configuration for command.
0x02 Invalid command type: 1=Write, 2=Read, All other errors.
0x04
0x08
0x10
0x20
0x40
0x80