ProSoft Technology AN-X-PB - Manual (Page 45)

AN-X-PBCAPT Page 41
Selecting an AN-X
Before you can perform an operation on an AN-X, you must select it.
Choose Utilities/Select An AN-X to select a specific AN-X.
From the Adapter list, select the network adapter that connects to the
Ethernet network that contains the AN-X.
In the Ethernet MAC Address field, enter the MAC Address of the AN-X
you wish to select. It can be found on the AN-X label or using the
Locate All AN-X Modules
command. The format is as shown above, six
pairs of hexadecimal digits separated by hyphens.
In the IP Address field, enter the Ethernet IP address of the AN-X you
wish to select. It can be found using the Locate All AN-X Modules
command. The format is as shown above, four decimal numbers each in
the range 0 to 255.
Both MAC address and IP address must match the settings on the AN-X
in order for communication to occur.