Philips GC7717/80 User Manual

Page 8

Advertising
background image

Safety auto-off mode (specific types only)

- To save energy, the steam generator switches off automatically when it has not been used for

15 minutes. The ‘iron ready’ light flashes.

- To reactivate the steam generator, set the on/off switch to ‘off’ position and then to ‘on’ position.

Troubleshooting

This chapter summarises the most common problems you could encounter with the appliance.

If you are unable to solve the problem with the information below, visit www.philips.com/support

for a list of frequently asked questions or contact the Consumer Care Centre in your country.

Problem

Possible cause

Solution

The iron does not

produce any

steam.

There is not enough water in

the water tank.

Fill the water tank beyond the MIN

indication. Press and hold the steam

trigger until steam comes out. It may take

up to 30 seconds until steam comes out.

You have not pressed the steam

trigger.

Press and hold the steam trigger until

steam comes out.

You have set the temperature

dial to 1.

Turn the temperature dial to 2 or

higher.

The steam function has been

disabled until you have

performed the Calc-Clean

process.

Perform the Calc-Clean process to

restore the steam function (see chapter

‘IMPORTANT - Cleaning and

maintenance’).

You have not placed the water

tank in the appliance properly.

Slide the water tank into the appliance

until it locks into place (‘click’).

The Calc-Clean

light flashes and

the appliance

beeps.

This is the Calc-Clean reminder.

Perform the Calc-Clean process within

1 hour after the Calc-Clean reminder is

given.

The Calc-Clean

light flashes and/or

the appliance

beeps.

You have not done or have not

completed the Calc-Clean

process.

Perform the Calc-Clean process to

enable the steam function again

(see chapter ‘IMPORTANT - Cleaning

and maintenance’).

The Calc-Clean

light flashes and

the appliance

beeps every time I

press the steam

trigger. No steam

comes out of the

soleplate.

You have not done or have not

completed the Calc-Clean

process.

Perform the Calc-Clean process to

enable the steam function again (see

chapter ‘IMPORTANT - Cleaning and

maintenance’).

ENGLISH

8

Advertising