Roborock Q7 Max FCC - Manual (Page 11)

11
Custom Cleaning Modes
• Scheduled
• Selective Room
• Zone
• No-Go Zones & Invisible Wall
• Custom
• Carpet Boost
Cleaning Mode Switch
• Suction Power Levels
• Mop Intensity Levels
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
More Features
• Firmware Update
• Volume Adjustment
• Language Selection
• Do Not Disturb mode
• Voice Assistant Support
Functions and details of the app may vary slightly
due to the continuous app development and updates.
Note:
Routine Maintenance C
C1
Main Brush
* Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C5-6— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
The omni-directional wheel bracket cannot be removed. Note:
C3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
C3-1 —Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
Clean the main wheels with a soft, dry cloth.
C4
Main Wheels
* Clean monthly
C5-2— Remove the filter then empty the dustbin.
C5-1— Open the upper cover of the robot
and take out the unit.
C5 Dustbin and Water Tank
Combo Unit
* Clean weekly and replace the filter every 6-12 months
C5-3— Empty the water tank of unused water.
C5-4— Fill the dustbin with clean water and
gently shake it. Then pour out the
dirty water.
C5-5— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
Note:
C3
Omni-Directional Wheel
* Clean as required
C2
Side Brush
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
* Clean monthly and replace every 3-6 months
C1-8— Rotate the main brush caps in the
indicated unlock direction to remove
the caps.
C1-9— Remove any hair or dirt entangled
around the main brush, reinstall the
main brush and re-insert the brush
cover, making sure to place the tabs
in the slots.
C1-10— Make sure that the main brush
cover has been properly attached.
When properly installed, all four tabs
should be hidden.
Notes:
• Main brush should be wiped down with wet cloth and
left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
C1-6— Turn over the robot and press the
latches to remove the main brush cover.
C1-7— Pull out the main brush and remove
the main brush bearing.
C1-4—Main Brush Caps
C1-5—Main Brush Bearing